Electric Gates, Garage Door, Access Control, Smart Home & Security Forums

Hi there guys first time poster stumbled across your forum while troubleshooting.
Would appreciate some help if there's any going.

Installed above opener today all went well but having a bit of trouble.
Gate will not open or close.
On the logic side when gate is open I get correct PI(03),when gate is closed correct PI (00) however if I attempt to open gate logic changes to stopped (02) until it's pushed all way open at which point PI changes to open (03) then when I got to close,it does not change over to now closing(06) rather remains in open logic until it changes to close.
I have one set of closing photocells, open fsw has been shorted along with the stop and edge.

What's throwing me is the stop command where is it being generated from

Anywhone any help on this would be much appreciated

All sorted

Hi Mozil

It looks like I have the same problem that you had.

How did you manage to resolve?

(07-09-2019, 08:33 PM)Mozil Wrote: [ -> ]Hi there guys first time poster stumbled across your forum while troubleshooting.
Would appreciate some help if there's any going.

Installed above opener today all went well but having a bit of trouble.
Gate will not open or close.
On the logic side when gate is open I get correct PI(03),when gate is closed correct PI (00) however if I attempt to open gate logic changes to stopped (02) until it's pushed all way open at which point PI changes to open (03) then when I got to close,it does not change over to now closing(06) rather remains in open logic until it changes to close.
I have one set of closing photocells, open fsw has been shorted along with the stop and edge.

What's throwing me is the stop command where is it being generated from

Anywhone any help on this would be much appreciated

Hi,  I am having the exact same issue, any chance you could post how you fixed it, thanks.