Electric Gates, Garage Door, Access Control, Smart Home & Security Forums

as an experienced electrician first attempt at swinging gates using one set of photocells inside gates following installation guide i connected them to open /close terms continued set up gates opening and closing on L1 but when i went to use transmitter nothing happens iknow i have teached trans properly and think my dips are set ok any help would be appreciated thanks

Hi, Have you set up the photocells? you do this by turning the power off, placing a jumper over the terminals labelled "Save Fail Safe Photocells", then turning the power back on and removing the jumper after 15 seconds.

Check the "Stop" circuit is connected, there should be a link between "Stop" and "Com".

Also check your radio board is plugged into the CB11.

Hope this helps,