Electric Gates, Garage Door, Access Control, Smart Home & Security Forums

Hi,

I recently installed a replacement lyn400 with a cb11 pcb. Every 2 - 3 days now the unit stops working. The only way to make it work is to switch off at the mains then restarts, after which it works fine for another couple of days. Any ideas?

I need some more information as too what is installed ie photocells keyswitches push buttons etc etc


The reset can be achieved by having the gates in the close possition then insert the jumper marked save failsafe photocells. Turn off the power wait 20 seconds tunr the power back on wait 20seconds then remove the jumper and the board will now be reset and ready to operate