Thread Rating:
  • 185 Vote(s) - 2.9 Average
  • 1
  • 2
  • 3
  • 4
  • 5
FAAC 750 Deceleration not working
#1
I have a FAAC 750 installation operating a single leaf gate. It works fine apart from when it enters the deceleration phase of the swing. I can hear the pump slow down and run at the lower speed when it enters the deceleration phase but the gate only moves at a very, very slow rate. Nothing like the rate it went when it was working properly. The hydraulic actuator operates normally across its full range of travel so I don't think it's the problem. Could it be the control board? It's a FAAC 455D board - is there any way to test the board?

Many thanks
Reply
#2
Answered my own question. It was a duff run capacitor.
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Faac 452 pcb board benner91 2 1,574 09-02-2024, 06:13 PM
Last Post: benner91
  Faac photocell stopped working Zeb Gulickx 2 832 28-01-2024, 12:56 PM
Last Post: Zeb Gulickx
  FAAC E124 fault 05 allan@amtas.com.au 0 697 14-10-2023, 12:37 PM
Last Post: allan@amtas.com.au
  FAAC 740 Sliding gate Just closes or Stops Paul L 1 3,756 03-07-2023, 08:54 AM
Last Post: Michael
  Rigel 5 - second keypad stopped working HarefieldHse 1 1,539 03-07-2023, 08:48 AM
Last Post: Michael
  7pcb452/455 FAAC Alpin 0 1,188 23-06-2023, 03:19 PM
Last Post: Alpin
Exclamation Proteco Q60A stopped working xCO 0 940 19-06-2023, 01:03 PM
Last Post: xCO
  FAAC Photocells mmc1977 3 2,275 02-05-2023, 12:37 PM
Last Post: Matt Turner
  Nice Robus RB100 - Control Board Buttons Not Working sl991 5 4,051 02-12-2022, 02:51 PM
Last Post: JoeF
  Wired up but not working Ranch2 7 4,543 18-11-2022, 10:02 AM
Last Post: SamA

Forum Jump:


Users browsing this thread: 1 Guest(s)