Thread Rating:
  • 263 Vote(s) - 2.69 Average
  • 1
  • 2
  • 3
  • 4
  • 5
nice electric gates
#1
hi guys,
I have a problem with my nice a6 electric gates.have read manual have not got 24 volts on terminals 21 and 22.think transformer is working .please help
cheers andy
Reply
#2
These contacts should definitely have 24V AC coming out of them. If you are not reading this low voltage output, I should check your low amp fuse on the board and also check for any burnt out tracks on the rear of the panel. Any water damage to the panel will be recognisable by white residue. If you link out the photocell contacts do the gates start functioning? If its just the accessory power output which has failed, rather than buying a new panel, you could use a separate PSU to power your photocells and other accessories.

(22-03-2014, 11:24 AM)rose.andy Wrote: hi guys,
I have a problem with my nice a6 electric gates.have read manual have not got 24 volts on terminals 21 and 22.think transformer is working .please help
cheers andy
Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Came ZA3 gates stuck open Ivorwindybottom 0 258 18-02-2024, 06:29 PM
Last Post: Ivorwindybottom
  Electric Gates with AllMatic BIOS2 Unit antsnaith 3 1,200 31-01-2024, 08:22 AM
Last Post: patronsecurity
  Came gates za3p Webby 4 8,819 07-01-2024, 07:11 PM
Last Post: Simon NW
  Disable Open hold On NICE NC824 paul@blxnetworks.co.uk 4 1,671 02-10-2023, 09:20 AM
Last Post: benbrooks
  Nice Gates not closing StuL 1 1,349 24-08-2023, 01:34 PM
Last Post: JoeF
  Gates Opening After Closing tht7 2 9,458 30-07-2023, 12:30 PM
Last Post: lcpbarbosa
  Nice Moonbus Photocells - Faulty? ddaddy 2 1,932 11-07-2023, 01:33 PM
Last Post: JoeF
  Nice HS400 Andruelectricgates 0 904 09-06-2023, 09:28 PM
Last Post: Andruelectricgates
  Hikvision DS-KD8003-IME1 video intercom to Nice Robus 600 gate motor help j1000 20 16,196 15-05-2023, 11:25 AM
Last Post: Nemen3242
  Came gates stuck open. Ring8180 7 16,650 23-02-2023, 01:08 PM
Last Post: SamA

Forum Jump:


Users browsing this thread: 1 Guest(s)