Hi,
The 3 flashes on the photo cell is showing that the photocells are not recognized by the control unit. First check you have the jumpers on the photocells on the correct setting and they are connected correctly to the ESCbus, then try the learn connected devices by holding down the P2 button for three seconds and release. Failing this working, you will require replacing the photocells as they have most likely become faulty. This could be due to insect damage or water damage, shorting across the terminals.
Tim
The 3 flashes on the photo cell is showing that the photocells are not recognized by the control unit. First check you have the jumpers on the photocells on the correct setting and they are connected correctly to the ESCbus, then try the learn connected devices by holding down the P2 button for three seconds and release. Failing this working, you will require replacing the photocells as they have most likely become faulty. This could be due to insect damage or water damage, shorting across the terminals.
Tim
Gate Automation and Access Control from EasyGates Retail Store
EasyGates Trade Store for Trade only
Smart Home Tech from The Smart and Secure Centre
Smart Home News from Smart Home Matters
EasyGates Trade Store for Trade only
Smart Home Tech from The Smart and Secure Centre
Smart Home News from Smart Home Matters