+- Electric Gates, Garage Door, Access Control, Smart Home & Security Forums (https://www.gateguide.co.uk)
+-- Forum: Member Discussions (https://www.gateguide.co.uk/forumdisplay.php?fid=33)
+--- Forum: Introduce Yourself (https://www.gateguide.co.uk/forumdisplay.php?fid=34)
+--- Thread: Connections for pulse (/showthread.php?tid=5411)
Connections for pulse - STEVESHORE - 25-02-2017
I am new to this forum and I am looking for advice on the above
Dear sir
We are using 2x Elka Schranken Sentinal and 2 x Daspi Eltra 400 barriers that are currently triggered to open via a RFID card reader.
We have now installed an Automatic Number Plate Reader camera system which outputs a 24v pulse to trigger the opening when a valid number plate is read.
Please can you advise where this pulse wires need to be connected
Regards
Steve Shore
+97150 4576736
RE: Connections for pulse - Automatic-TC - 25-02-2017
(25-02-2017, 08:01 AM)STEVESHORE Wrote: I am new to this forum and I am looking for advice on the above
Dear sir
We are using 2x Elka Schranken Sentinal and 2 x Daspi Eltra 400 barriers that are currently triggered to open via a RFID card reader.
We have now installed an Automatic Number Plate Reader camera system which outputs a 24v pulse to trigger the opening when a valid number plate is read.
Please can you advise where this pulse wires need to be connected
Regards
Steve Shore
+97150 4576736
hi
you want disconect card reader and install instead of it camera plate reader?
or you want use both of them ?