Electric Gates, Garage Door, Access Control, Smart Home & Security Forums

Full Version: Gates out of sync
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
I have a set of double gates that are operating with the came frog system. The problem that just developed, is the gates are out of sync. The left side opens while the right side is closing. Would appreciate any help or suggestions on this senario
(07-01-2018, 10:38 AM)frankjboyd Wrote: [ -> ]I have a set of double gates that are operating with the came frog system. The problem that just developed, is the gates are out of sync. The left side opens while the right side is closing. Would appreciate any help or suggestions on this senario

hi



that's happened probably because of cold weather .
can i know the control board type / name

is this za3 ??

regards
(07-01-2018, 03:25 PM)Automatic-TC Wrote: [ -> ]
(07-01-2018, 10:38 AM)frankjboyd Wrote: [ -> ]I have a set of double gates that are operating with the came frog system. The problem that just developed, is the gates are out of sync. The left side opens while the right side is closing. Would appreciate any help or suggestions on this senario

hi



that's happened probably because of cold weather .
can i know the control board type / name

is this za3 ??

regards
Hi All,
I have the same issue with my Came system where one game opens when the other closes.
One of the motors was replaced last week but is out of sync
The board is a za3
Has anyone seen this issue before?
(31-12-2022, 01:31 PM)Murphe5 Wrote: [ -> ]Hi All,
I have the same issue with my Came system where one game opens when the other closes.
One of the motors was replaced last week but is out of sync
The board is a za3
Has anyone seen this issue before?

Issue resolved, I switched the polarity on the new motor. Working good now.
(03-01-2023, 04:14 PM)Murphe5 Wrote: [ -> ]
(31-12-2022, 01:31 PM)Murphe5 Wrote: [ -> ]Hi All,
I have the same issue with my Came system where one game opens when the other closes.
One of the motors was replaced last week but is out of sync
The board is a za3
Has anyone seen this issue before?

Issue resolved, I switched the polarity on the new motor. Working good now.

Hi,

Great to hear Smile

Sam.