Electric Gates, Garage Door, Access Control, Smart Home & Security Forums

Hi all !
Just got a magloc for cameZA4 but there is no loc terminals.
Have a 240/12 dc transformer and a tic relay board but can't suss out the NC/NO side of things
Help !!!!
Thanks in advance

Hi,

On mag locks, you always use the NC terminals, this is because you want power permanently to the lock until you trigger the gates which will then change the state to normally open. This will remove the power temporarily to allow the gates to unlock.

(12-09-2017, 01:39 PM)Stocky Wrote: [ -> ]Hi all !
Just got a magloc for cameZA4 but there is no loc terminals.
Have a 240/12 dc transformer and a tic relay board but can't suss out the NC/NO side of things
Help !!!!
Thanks in advance

Thanks for reply, have just received a diagram from came .
??